Terms And Conditions Please Read and Accept the Daytona Drone Club Terms to participate in the Forum
Notifications
Clear all
Topic starter
April 26, 2021 6:40 am
https://docs.cubepilot.org/user-guides/carrier-boards/kore-carrier-board
https://www.spektreworks.com/products/multi-rotor-pixhawk21-carrier-board
https://ardupilot.org/copter/docs/common-bootloader-update.html
This topic was modified 4 years ago 5 times by admin
Topic starter
April 29, 2021 4:54 am
The crossfire nano setup works the PPM input is where the wires go. Setting up mission planner was a success with ardupilot then I flashed PX4 and lost it. Will
post the radio setup next. I had here3 for canbus but it crashed so this 20 dollar unit is being used to get wheels up
This post was modified 4 years ago by admin