Terms And Conditions Please Read and Accept the Daytona Drone Club Terms to participate in the Forum
Last seen: July 13, 2024 8:52 pm
VTX is set to 25mW by default! Power levels above 25mW require a HAM license or have to be approved by local authorities!
Next step getting motors spinning. radio control says communication but no motor movement Kore Carrier wiring has option to power the esc, jumper c...
Here3 gps overall not worth the trouble and definately not worth 125 bucks I abandoned the canbus and was able to wire up the here 3 in i2c mode. di...
Summary: there are 2 firmwares that get flashed to the cube. PX4 or ardupilot At this point I am using px4 because it configures the remote radio, th...
The current ststus is the here3 is connected to the can1 portin mission planner I go to setup/optional hardware/uavcan then select SLCan Mode CAN1 and...
These are the components and the instructions on how to setup a paticular device will follow. Hopefully it will be a here3 gps Enabling CAN interfac...
The crossfire nano setup works the PPM input is where the wires go. Setting up mission planner was a success with ardupilot then I flashed PX4 and los...
Wiring the transmitter NOTE: The out RX goes to the IN TX on the boards your installing . It sounds silly but you dont connect rx to rx, ...