I purchased a can bus GPS and was able to get mission planner to recognize it. going to the website to check for software update I followed the ...

I spent the past week working with and trying to understand the telemetry system. Mavlink and a pair of junk Holybro telemetry radios. With that time ...

So this has taken a slight turn. Going through the assembly, having a small fire and lots of wiring disasters there has been some progress made a...

update: After a few months the holybro SIK transmitters sorted themselves out. They took an update and started working proper. I went ahead and starte...

Not to get off track the purpose of all this brain strain is to figure out about canbus and why my here3 gps isn't working. here are a couple new i...

On of the most interesting things so far is the canbus controlling the ESC, This is a update I will explore. This is a Zubax combination motor/ESC, it...

Here we go. Starting to pick up some pieces SLCAN (sometimes referred to as LAWICEL protocol) is the protocol you are looking for. There is no form...

The Kore board made a connection I believe, the pixhawk 4 said no now to figure out what is says, discovery not possible This is the response...

Why would they make this note. Note that the PMB does not supply power to theservos via + and - pins of FMU PWM-OUT. The size of the motor ESC wi...

I get a clue with this mini wiring photo

This is where I start to build a information base for the purpose of troubleshooting an inop here3 NOTE: The SLCAN turns Cube into UAVCAN c...

If you followed the ser #1 build it was using a here3 from holybro. the manual from the cubepilot site explains setting up the GPS for canbus. St...